Improvements to RETAINING WALL
- Open
- Subscribe
|
R |
Robert |
A couple suggestions for improvement
1. On the Detailed Report - under INPUTS - FOOTING - list the total width of the footing as input on - as it is, I have to add three numbers - toe, stem and heel to check it.
2. It would be useful to include dimensions on the sketch, as shown on the screen when working it.
3. Recently ANALYZED a design and all three elements gave PASS GREEN so I thought my design was good. However, when I read the Detailed Report, I found the Stem offset and caused a FAIL in the bearing not indicated by the GREEN PASS. Might want to figure a way to indicate that as well before finding it in the detailed report
Otherwise - it is a GREAT DESIGN AID!
Thanks
Bob